News for hackers. Stuff that matters.

tedwilliamsis

Re:DIY control pedal on Linux on Tuesday September 08, 2015 @12:42PM (#10186740)
I did something similar once, entirely in hardware, by soldering a normally-open foot pedal switch to the keyboard's controller chip.

In most keyboards, a keypress is registered during the connection of two conductive pads on two separate membranes, each of which contain a trace back to a controller chip. You can take a keyboard apart, look at where the Ctrl key is, then visually follow the traces back to their respective pins on the chip. Soldering a switch to those two pins will register with the keyboard exactly as if that key were pressed.