jrogers
As for road legal, you are thinking of passenger car specs, this vehicle would classify as a mixed use vehicle in which case many of the FMVSS specs to which you are referring would not be applicable. Hope that helps.
As for buggies and dirtbikes occupying the market...I guess I am just not going to be able to convince you and should not try. But here goes. ATVs and Bikes are a TOTALLY different experience which require a much more fit rider and mindset. Buggies are not anywhere near as capable as "trucks" made for this landscape (to be precise, we are talking about 25mph max vs 70mph avg.) Then there is the subject of Pre-running. Much of it today is done either in sand-rail/types or in sup'd up F-150/types. Most races (i.e. Reno to Vegas) are pre-run in a column of cars where you are simply eating dust the entire day. So sandrails are miserable, go ask John Marking of Fox Racing. As for sup'd up F-150 types after spending in excess of 150K you will have 10 inches of wheel travel and a 7000lb vehicle that needs a 700+ hp engine to move it, and it becomes a veritable space race of mass and power. The whole point is that no company has ever seen the profit in making cars for this size market, but LM makes cars with a much lower break-even volume allowing us to access a much smaller niche. Even if you are right and the market is not as large as we would want, we will have invested less than $2MM in the build program, so we can afford to scrap it and move on to the next ...compare this to Fisker or Tesla (other startup car co.'s) that have each raised in excess of $200MM and only have 1 model competing in very VERY busy marget segments.
As for MA, you are at Y-Combinator and should understand this. Just because we are starting in MA doesn't mean that we are finishing here. We are in a small startup Ops Center. We have 2 letters of intent on properties in Phoenix and are already working on our MA model. When we started we had no idea that the community would like the performance off-road desert racing segment, so we couldn't predict where would be best to go...so we dove in and got started. Hindsight is 20-20, but I prefer to get going. After all, this is unlike any start-up in any typical venture type market, so some of the nimble ideas do not apply as well. We are building a car company in an intensely difficult time and are taking risks where we feel appropriate and necessary and taking them large. Where we do not need to take risk, we are intensely conservative. I also hope that this helps.
Again, I am so stoked that you care enough to dig and to answer. I really think that our community could use your insight...hope you will join www.local-motors.com
As for road legal, you are thinking of passenger car specs, this vehicle would classify as a mixed use vehicle in which case many of the FMVSS specs to which you are referring would not be applicable. Hope that helps.
As for buggies and dirtbikes occupying the market...I guess I am just not going to be able to convince you and should not try. But here goes. ATVs and Bikes are a TOTALLY different experience which require a much more fit rider and mindset. Buggies are not anywhere near as capable as "trucks" made for this landscape (to be precise, we are talking about 25mph max vs 70mph avg.) Then there is the subject of Pre-running. Much of it today is done either in sand-rail/types or in sup'd up F-150/types. Most races (i.e. Reno to Vegas) are pre-run in a column of cars where you are simply eating dust the entire day. So sandrails are miserable, go ask John Marking of Fox Racing. As for sup'd up F-150 types after spending in excess of 150K you will have 10 inches of wheel travel and a 7000lb vehicle that needs a 700+ hp engine to move it, and it becomes a veritable space race of mass and power. The whole point is that no company has ever seen the profit in making cars for this size market, but LM makes cars with a much lower break-even volume allowing us to access a much smaller niche. Even if you are right and the market is not as large as we would want, we will have invested less than $2MM in the build program, so we can afford to scrap it and move on to the next ...compare this to Fisker or Tesla (other startup car co.'s) that have each raised in excess of $200MM and only have 1 model competing in very VERY busy marget segments.
As for MA, you are at Y-Combinator and should understand this. Just because we are starting in MA doesn't mean that we are finishing here. We are in a small startup Ops Center. We have 2 letters of intent on properties in Phoenix and are already working on our MA model. When we started we had no idea that the community would like the performance off-road desert racing segment, so we couldn't predict where would be best to go...so we dove in and got started. Hindsight is 20-20, but I prefer to get going. After all, this is unlike any start-up in any typical venture type market, so some of the nimble ideas do not apply as well. We are building a car company in an intensely difficult time and are taking risks where we feel appropriate and necessary and taking them large. Where we do not need to take risk, we are intensely conservative. I also hope that this helps.
Again, I am so stoked that you care enough to dig and to answer. I really think that our community could use your insight...hope you will join www.local-motors.com
As for road legal, you are thinking of passenger car specs, this vehicle would classify as a mixed use vehicle in which case many of the FMVSS specs to which you are referring would not be applicable. Hope that helps.
As for buggies and dirtbikes occupying the market...I guess I am just not going to be able to convince you and should not try. But here goes. ATVs and Bikes are a TOTALLY different experience which require a much more fit rider and mindset. Buggies are not anywhere near as capable as "trucks" made for this landscape (to be precise, we are talking about 25mph max vs 70mph avg.) Then there is the subject of Pre-running. Much of it today is done either in sand-rail/types or in sup'd up F-150/types. Most races (i.e. Reno to Vegas) are pre-run in a column of cars where you are simply eating dust the entire day. So sandrails are miserable, go ask John Marking of Fox Racing. As for sup'd up F-150 types after spending in excess of 150K you will have 10 inches of wheel travel and a 7000lb vehicle that needs a 700+ hp engine to move it, and it becomes a veritable space race of mass and power. The whole point is that no company has ever seen the profit in making cars for this size market, but LM makes cars with a much lower break-even volume allowing us to access a much smaller niche. Even if you are right and the market is not as large as we would want, we will have invested less than $2MM in the build program, so we can afford to scrap it and move on to the next ...compare this to Fisker or Tesla (other startup car co.'s) that have each raised in excess of $200MM and only have 1 model competing in very VERY busy marget segments.
As for MA, you are at Y-Combinator and should understand this. Just because we are starting in MA doesn't mean that we are finishing here. We are in a small startup Ops Center. We have 2 letters of intent on properties in Phoenix and are already working on our MA model. When we started we had no idea that the community would like the performance off-road desert racing segment, so we couldn't predict where would be best to go...so we dove in and got started. Hindsight is 20-20, but I prefer to get going. After all, this is unlike any start-up in any typical venture type market, so some of the nimble ideas do not apply as well. We are building a car company in an intensely difficult time and are taking risks where we feel appropriate and necessary and taking them large. Where we do not need to take risk, we are intensely conservative. I also hope that this helps.
Again, I am so stoked that you care enough to dig and to answer. I really think that our community could use your insight...hope you will join www.local-motors.com
As for road legal, you are thinking of passenger car specs, this vehicle would classify as a mixed use vehicle in which case many of the FMVSS specs to which you are referring would not be applicable. Hope that helps.
As for buggies and dirtbikes occupying the market...I guess I am just not going to be able to convince you and should not try. But here goes. ATVs and Bikes are a TOTALLY different experience which require a much more fit rider and mindset. Buggies are not anywhere near as capable as "trucks" made for this landscape (to be precise, we are talking about 25mph max vs 70mph avg.) Then there is the subject of Pre-running. Much of it today is done either in sand-rail/types or in sup'd up F-150/types. Most races (i.e. Reno to Vegas) are pre-run in a column of cars where you are simply eating dust the entire day. So sandrails are miserable, go ask John Marking of Fox Racing. As for sup'd up F-150 types after spending in excess of 150K you will have 10 inches of wheel travel and a 7000lb vehicle that needs a 700+ hp engine to move it, and it becomes a veritable space race of mass and power. The whole point is that no company has ever seen the profit in making cars for this size market, but LM makes cars with a much lower break-even volume allowing us to access a much smaller niche. Even if you are right and the market is not as large as we would want, we will have invested less than $2MM in the build program, so we can afford to scrap it and move on to the next ...compare this to Fisker or Tesla (other startup car co.'s) that have each raised in excess of $200MM and only have 1 model competing in very VERY busy marget segments.
As for MA, you are at Y-Combinator and should understand this. Just because we are starting in MA doesn't mean that we are finishing here. We are in a small startup Ops Center. We have 2 letters of intent on properties in Phoenix and are already working on our MA model. When we started we had no idea that the community would like the performance off-road desert racing segment, so we couldn't predict where would be best to go...so we dove in and got started. Hindsight is 20-20, but I prefer to get going. After all, this is unlike any start-up in any typical venture type market, so some of the nimble ideas do not apply as well. We are building a car company in an intensely difficult time and are taking risks where we feel appropriate and necessary and taking them large. Where we do not need to take risk, we are intensely conservative. I also hope that this helps.
Again, I am so stoked that you care enough to dig and to answer. I really think that our community could use your insight...hope you will join www.local-motors.com
1 - we are using the 335i engine. And it is one of 3 engine systems we have fitted for the rally fighter. So I agree.
2 - Our entire business is a revolutionary auto business model, so we are structured to do niche production and make that our winning strategy. Each micro-factory serves only a regional area. 2000cars max production. Kinda like IKEA or Cabella's for cars. So call it a minority and you would be right. As for desert racing. It is a big deal in the American Southwest, so we believe it will be successful. The whole point is that since people like you (and me) don't off-road race and don't really know about it, that big companies like Honda, Chevy, and BMW will never make a car that works for this minority since the market isn't big enough to support their massive tooling costs...voila a market opportunity is created for a startup company. Since the Rally Fighter is on and off road legal and seats 2 adults in front and 2 in back (or 3 car seats), it is not my definition of a toy. But I certainly want people to think of it as the most fun car and experience that they have ever bought.
I love your thoughts, and I so wish you were making these critiques on our forum so our community could hear your thoughts. We are about to launch a general forum and perhaps we can entice you to post there.
We will soon be choosing our next LM model to make with the help of our community, and we would love to have you involved in that choice.
Thought you might want to checkout this post last night by Jeff Jarvis on his BuzzMachine Blog. The comment stream there shows the breadth of opinion. http://bit.ly/9CRkv